HID pivCLASS

pivCLASS

As an embedded computer packaged in a small form factor with pre-installed, updatable firmware, HID’s pivCLASS Authentication Modules (PAM) enables physical access control systems (PACS) to upgrade to FIPS 201 compliance by performing the FIPS 140-certified cryptographic functions the typical PACS panel cannot.

The PAM is installed between a supported reader and the existing access control panel and provides configurable Wiegand output to the controller. This enables the system to be upgraded to support PIV or any FIPS 201-compliant cards for access control without replacing the existing PACS panels. Similarly, much of the existing wiring may be reusable.

pivCLASS Authentication Module supports a range of commercially available contact, contactless and biometric readers, including the extensive line of pivCLASS readers.

HID Global’s pivCLASS Authentication Module (PAM) is configured and managed from the host PACS server using the pivCLASS Reader Services application. Using Reader Services, the administrator can select the reader types to be controlled by a PAM for specific doors or other access points. It is also used to set the authentication modes on a per door basis in each PAM. These modes can be changed dynamically from the host PACS using this application.

Specifications

Dimensions

  • Board – 6.7″ x 6.05″ (17 cm x 15.4 cm)
  • Enclosure – 16″ x 16″ x 3.5″ (18.6 cm x 16.8 cm)

Interface to Readers

  • Number Channels – Supports 1 or 2 readers at 1 or 2 doors
  • Communication – 2 RS-485 serial ports
  • Protocols – CoreStreet Reader Protocol (CSRP), HID pivCLASS

Interface to PACS Controller

  • Number Channels – Output for 1 or 2 readers
  • Communication – 2 Wiegand ports

Interface to PVS Management System

  • Protocol – Ethernet TCP/IP
  • Security – Optional 256-bit AES encrypted Ethernet TCP/IP
  • Initial Configuration Security – Web interface enabled/disabled with DIP switch

Compliance & Certification

    • PVS Management Station Interface – 256-bit AES encryption
    • Crypto Firmware – FIPS 140-2 Level 1 certified
    • Safety – FCC, UL 294
    • Module Warranty – 18 months

Operational

  • Memory – 2GB SD flash memory card (standard)
  • Number Cardholders – Up to 100,000
  • Firmware – Centralized, automated management of PAM firmware updates is provided by pivCLASS Validation Server (PVS)
  • Offline Operation – Functions normally if communication to the PVS Management Station is interrupted
  • Operation Interface – Embedded browser-based interface for initial configuration, network settings and hardware options. Full PAM configuration and management via pivCLASS Validation Server’s Management Station.

Reviews

There are no reviews yet.

Be the first to review “HID pivCLASS”

Your email address will not be published. Required fields are marked *